#How to flash cleanflight firmware how to
#How to flash cleanflight firmware install

Then soldered these cables to the power distribution board. Next step was cutting the power cables from the ESC, so these can fit on the bottom plate. Took the bottom center plate and mounted the power distribution board with on it. I also removed the 5V and GND cables from 3 ESCs and left only the signal cable (I was going to use the supplied BEC on the fourth one). Then unsoldered the original motor cables from every ESC. Next I mounted the MN2206 motors on the arms and cut the 2mm gold connectors as I was going to solder the motor cables directly to the ESCs.

#How to flash cleanflight firmware install

Thanks to Bill, who told me about the video and to FranzArians for sharing his way to install the firmware!ДЇirst I mounted the M3 6mm nylon spacers on the top center plate. If for some reason you want to go back to the OpenPilot firmware, go to this page and follow the exact instructions вЂњHow to Upgrade the Bootloader and Erase SettingsвЂќ. Then you can connect it to the Cleanflight Configurator. Important: To use the board through the UBS-Port, you need to power it with external battery. ThatвЂ™s it, now you have the Cleanflight firmware on your CC3D board. Check the вЂњI know what IвЂ™m doing!вЂќ box and then вЂњFlashвЂќ button. Now you can open the downloaded cleanflight_CC3D.bin.

Open the OpenPilot GCS software, connect the CC3D board through the USB-Port, go to the вЂњFirmwareвЂќ-Tab and click the вЂњHaltвЂќ button. Download the вЂњ cleanflight_CC3D.binвЂќ from GitHub. Install the Cleanflight Configurator from the Chrome Web Store and download the latest Cleanflight firmware for the CC3D board. Download it from the official ST-webpage and install it. We also need the STM32 Virtual Com Port driver.

#How to flash cleanflight firmware how to

Here is a manual how to install it, if you have some problems with that. I have tried it yesterday and will show you, how to do this if you donвЂ™t want to watch the video.ДЇirst download the OpenPilot GCS 15.02.02 (the newest 15.05 does not support the CC3D board) and install it on your computer. I used my Arduino Nano as FTDI adapter to do this, but Bill posted a video in the comments, how the board can be flashed only through the USB-Port. In one of my previous post, I described how to flash the Cleanflight firmware on the CC3D flight controller and why I prefer the CC3D over Naze32 at the moment.